Description
When you’re working through tough ground or heavy crop residue, worn-out harrow tines just make the job harder than it needs to be. If you’ve noticed your cultivator isn’t agitating the soil like it used to, or it’s leaving untouched strips between passes, it’s probably time to replace those old springs. This double coil harrow tine brings back that aggressive soil action you need for proper seedbed preparation.
What You’re Getting
- Heavy-duty 0.375-inch wire construction that flexes without breaking under load
- Double coil design provides maximum soil penetration and mixing action
- 13-1/2 inch length gives you the right reach for thorough cultivation
- 3-1/4 inch spacing between coils matches your existing setup perfectly
- Direct replacement tine—no modifications needed to your existing brackets
Built for Real Farm Work
These tines are designed specifically for John Deere field cultivators that handle the heavy lifting in soil preparation. Whether you’re working corn stubble in the fall, preparing ground for spring planting, or breaking up compaction from harvest traffic, this tine delivers the aggressive action you need to get the job done right.
Made to Last
The 0.375-inch spring steel wire construction can handle rocks, roots, and hard-packed soil without losing its temper. The coil design lets the tine flex over obstacles instead of breaking, while the heat-treated steel maintains its spring tension season after season. You’ll get years of reliable performance from these replacement tines.
Good to Know
Installation is straightforward—just remove the old tine from the mounting bracket and slide the new one in place. Make sure to check your bracket bolts while you’re at it, as loose hardware can cause premature tine wear. When replacing tines, it’s usually best to do the whole section at once so you get even cultivation across your working width.
Reviews
There are no reviews yet.