Description
When the sprockets on your planter or drill start showing wear, you know it’s time to swap them out before you end up with seed spacing issues or chain problems. This #40 chain weld sprocket with 32 teeth is built to handle the demands of field work and keep your equipment running smooth through long planting seasons.
What You’re Getting
- X-Series hub design that fits standard #40 chain drive systems found on many agricultural implements
- Weld construction that holds up to the constant stress of chain-driven seed meters and drive systems
- 32 teeth provide the right gear ratio for maintaining proper seed spacing and chain speed
- Direct replacement that installs just like the original – no modifications needed
Built for Real Farm Work
These sprockets are commonly used on planters and drills where precise chain drive operation is critical for accurate seed placement. Whether you’re running a grain drill for small seeds or a corn planter with precision metering, this sprocket helps maintain the timing your equipment was designed for.
Made to Last
Agricultural sprockets take a beating from dirt, moisture, and constant operation during planting season. This one’s built with welded construction that won’t come apart under load, and the teeth are machined to mesh properly with #40 chain for smooth operation and reduced wear.
Good to Know
Check your chain condition when replacing sprockets – worn chains will wear out new sprockets faster. A little grease on the hub before installation helps prevent corrosion and makes future removal easier if needed.
Reviews
There are no reviews yet.