12 Series Implement Yoke with 7/8 Inch Square Bore for PTO Driveline Connections

Description

When your implement’s PTO connection is getting sloppy or the square bore has worn out from years of field work, you need a yoke that’ll give you that solid, precise fit again. This 12 series implement yoke with a 7/8 inch square bore is built to handle the steady power demands of mid-size implements without the overkill of heavier series. If you’ve ever had a PTO yoke fail in the middle of haying season, you know how fast a simple part can shut down your whole operation.

What You’re Getting

• Precisely machined 7/8 inch square bore that slides on smooth and stays tight through seasons of use
• 12 series strength perfect for tractors in the 30-60 horsepower range running moderate PTO loads
• 3-1/2 inch center-to-end measurement that works with standard driveline spacing
• Weasler quality construction with agricultural-grade materials built for real farm conditions

Built for Real Farm Work

This Series 12 yoke is right at home on implements like smaller rotary cutters, tedders, rakes, and other PTO equipment that doesn’t need the beef of a Series 14 or higher. It’s perfect for those tractors running lighter to moderate implements where you need reliable power transfer without going overboard on capacity. The square bore design is common on many implements, especially older equipment and specialized applications where round splines aren’t used.

Made to Last

Weasler doesn’t mess around – their yokes are forged tough and machined to tight tolerances. That square bore is cut precisely so it slides on smooth but doesn’t slop around after a season of use. The bearing surfaces are ground smooth and the cross assembly is built to handle the constant speed changes and angles that come with real field work.

Good to Know

Installation is straightforward if you know what you’re doing. Slide the yoke onto your implement’s 7/8 inch square shaft and secure it with the appropriate hardware (usually a bolt through the shaft). Make sure you’ve got the right series match – this Series 12 needs to mate with other Series 12 components for proper fit. Check that your driveline length allows proper operation without binding or separating at full extension.