Description

When you’re mounting implement brackets, securing guards, or attaching accessories to your tractor, you need hardware that stays put. This 1/4 inch carriage bolt with its square head design grips into the mounting surface to prevent spinning, giving you the secure connection your equipment needs to handle field work without loosening up.

What You’re Getting

Grade 5 steel construction handles the vibration and stress of agricultural applications
Zinc plating resists corrosion from moisture, fertilizers, and field conditions
Square head design locks into mounting holes to prevent the bolt from turning during installation
Standard UNC thread pitch works with common nuts and hardware you already have on hand
1-1/2 inch length provides good thread engagement for secure mounting

Built for Real Farm Work

This size carriage bolt is perfect for lighter mounting jobs around the farm—think implement shields, bracket assemblies, small toolboxes, and accessory mounting. You’ll find it handy for securing guards on mowers, mounting work lights on utility tractors, or attaching brackets to loader frames where you need a clean, flush appearance on one side.

Made to Last

Grade 5 steel gives you the strength to handle agricultural loads without stretching or breaking. The zinc coating holds up better than plain steel in farm environments where moisture and chemicals are part of daily life. This is the same grade of hardware that equipment manufacturers use on their machines.

Installation Notes

The square head fits into a square hole or notch to keep the bolt from spinning while you tighten the nut from the other side. If you’re drilling your own holes, a standard round hole works fine—just hold the head with pliers or a wrench while tightening. Always use a washer under the nut for best holding power and to prevent pull-through on thin material.