Description

When your transmission starts leaving spots under your tractor or you notice fluid levels dropping, a worn housing seal is often the culprit. This seal is designed for use in axle housings, transmission cases, and other rotating equipment where keeping grease contained is critical. A leaking transmission doesn’t just waste expensive fluid—it’s a sign that contaminants can get in and cause serious internal damage that costs way more than a simple seal replacement.

What You’re Getting

Quality rubber compounds and reinforced construction to handle years of service with a metal case that won’t distort under pressure
Sealing lip that stays flexible even in cold weather for reliable operation year-round
Precision-fit design that prevents both fluid loss and contamination ingress
Built to handle the constant pressure and temperature changes of transmission operation

Built for Real Farm Work

These tractors deliver dependable power for intensive farming operations requiring consistent transmission performance, from New Holland TM series tractors (115 to 190 horsepower) to Case IH Maxxum series providing mid-range power with advanced transmission systems. Whether you’re pulling heavy implements through tough soil, running a PTO-driven implement all day, or doing loader work around the farmyard, your transmission works hard and needs proper sealing to maintain fluid levels and prevent contamination.

Made to Last

Farm equipment seals take a beating from temperature swings, chemical exposure, and constant flexing, so this seal uses quality rubber compounds and reinforced construction to handle years of service. It’s built to resist the harsh chemicals found in modern transmission fluids while maintaining flexibility through freeze-thaw cycles that would crack inferior seals.

Good to Know

Clean the housing thoroughly before installation and check that the shaft isn’t scored or damaged—a rough surface will tear up a new seal in no time. A thin coat of grease on the seal lip helps with initial startup. This is a direct replacement that fits properly without modifications, but take your time during installation—rushing this job usually means doing it twice.