Description

When you’re working tough ground or trying to break through hardpan without plugging up, a good chisel point makes all the difference. This reversible spike cuts through compacted soil and crop residue while the V-point design sheds material to keep things moving. When one end starts to wear, just flip it around and keep going – that’s what makes these points such a smart buy.

What You’re Getting

Reversible design gives you twice the wear life compared to single-use points
Sharp V-point nose cuts clean while shedding residue to prevent plugging
5/8-inch thick construction handles rocky conditions and high-impact tillage
Standard 1/2-inch plow bolt holes on 2-1/4 inch spacing fit most common shanks
13-inch length provides good penetration without excessive draft

Built for Real Farm Work

This spike is designed for chisel plows, toolbar shanks, and coil shanks – especially those 8-inch radius low clearance setups that need to slip under crop residue. Whether you’re doing primary tillage in corn stubble, breaking up compaction in wheat ground, or working through tough sod, this point handles the job without breaking the bank.

Made to Last

Quality steel construction stands up to rocks, roots, and the constant flexing that comes with field work. The reversible design means you get maximum value from each point, and when it finally wears out completely, replacement is straightforward with standard bolt patterns.

Good to Know

Installation is simple with standard plow bolts – just make sure your shank can handle the 2-1/4 inch spacing. Keep a few spares on hand since wearing parts like this are easier to replace in the shop than out in the field. When you flip to the fresh end, check your bolt torque to make sure everything stays tight.