Description

When you’re running a scraper, the pivot pins are what let your bowl lift, lower, and angle properly to get a good bite on the ground. If you’ve noticed your scraper isn’t cutting as clean or the hydraulics seem to work harder than they used to, worn pivot pins might be the culprit. This heavy-duty replacement pin keeps your scraper operating smoothly so you can move dirt efficiently.

What You’re Getting

Precision-machined 1.75″ diameter pin built to handle the stress of heavy earthmoving
9.6″ length provides the proper fit and spacing for your scraper’s pivot points
Heat-treated steel construction resists wear and deformation under load
Direct replacement that restores proper geometry to your lift mechanism

Built for Real Farm Work

This pin is engineered specifically for Reynolds 15C and 17C scrapers—machines that move serious amounts of dirt for pond construction, road maintenance, and field leveling. These scrapers see hard use in tough conditions, and the pivot pins take all the stress when you’re cutting, carrying, and spreading material.

Made to Last

Scraper work puts enormous forces on pivot pins as the bowl cycles through cutting and dumping. This pin is manufactured from quality steel and properly heat-treated to handle those loads without bending or wearing out prematurely. The precise machining ensures smooth operation of your hydraulic lift system.

Good to Know

Installation requires removing the old pin and pressing in the new one—you’ll likely need a shop press for this job. Check the bushings at the same time, as worn bushings will cause premature pin failure. A little grease on the pin during installation helps with future service.