Description

When your disc harrow’s transport wheel starts wobbling or making noise, it’s usually time to replace that spindle. This heavy-duty spindle is built for Case IH 480-490 disc harrows and gets your transport wheels rolling smooth again so you can move between fields without worrying about wheel problems slowing you down.

What You’re Getting

Two precisely located holes for 3/8″ bolts – one at 2″ from back and one at 3-1/2″ from back for secure mounting
1-3/4″ diameter shaft that fits the standard hub bearing setup
10-11/16″ length gives you the right spacing for proper wheel alignment
Direct replacement design – no modifications needed to your existing setup

Built for Real Farm Work

This spindle works with Case IH transport wheel systems found on models 48, 470, 475, 480, 490, 500, 501, 610, 760, 770 and early 496 (1987 and before). These are the workhorses that pull disc harrows through all kinds of field conditions, from spring tillage to fall stubble work.

Made to Last

Farm transport wheels take a beating bouncing down gravel roads and across rough field edges. This spindle is built with the same quality standards as the original equipment, using materials that can handle the constant vibration and side loads that come with moving heavy implements.

Good to Know

The spindle nut and washer are sold separately – you’ll want to pick up part numbers 912945 (nut) and 913608 (washer) if yours are worn. A quick tip: pack the hub with fresh grease while you’ve got the wheel off, and check those bearings for any rough spots.