Description

When you’re in the middle of harvest and grain starts backing up in the hopper instead of flowing out, the problem’s usually a slipping or broken unload auger drive belt. This PIX replacement belt gets your unload auger spinning properly again so grain flows smoothly into your wagon or truck. No more watching good grain pile up while you fiddle with a worn-out belt that can’t grip the pulleys.

What You’re Getting

PIX construction built to handle the constant start-stop cycles of combine unloading
Proper grip and tension to keep the auger spinning at the right speed
Heat and oil-resistant materials that hold up in dusty harvest conditions
Direct replacement that fits without modifications or adjustments

Built for Harvest Work

This belt fits Ford New Holland combines where the unload auger does the heavy lifting of moving grain from the tank to your transport. Whether you’re running corn, soybeans, wheat, or other crops, the unload system takes a beating during long harvest days. The belt has to grip reliably when the auger is under load and keep running smoothly through dust, chaff, and temperature swings.

Made to Last

PIX belts are designed specifically for agricultural applications where reliability matters. The rubber compound resists cracking from heat and stretching from heavy loads. The reinforced construction handles the shock loads that come with starting a full auger or dealing with slugs of wet grain.

Good to Know

Installation usually takes about 30 minutes once you get the shields off. Check the pulleys for wear and proper alignment while you’re changing the belt. A quick tip: run the engine at idle for a few minutes after installation to make sure everything tracks properly before you load up the hopper again.